Motion detector (PIR)
Automatic lighting control based on presence and brightness
150° detection angle
For outdoor use
Additional creep under protection
Sensor head can be turned by ± 90° horizontally and by 40° downwards
Mixed light measurement suitable for the control of fluorescent, incandescent and halogen lamps
Single-handed plug-in installation with retained screws
Instant start-up possible via factory preset
Adjustable brightness switching value and switch-off delay
Sensitivity can be reduced to limit detection area
Controls are place protected

Operating voltage 230 V AC
Frequency 50 – 60 Hz
Stand-by consumption 0,9 W
Light measurement Mixed light measurement
Number of channels 1
Type of contact NO contact
Installation type Wall installation
Setting range brightness 5 – 1000 lx
Switching capacity light

10 A (at 230 V AC, cos ? = 1), 6 A (at 230 V AC, cos ? = 0.6), 3 AX (at 230 V AC, cos ? = 0.3)
Detection angle 150°
Switching output Potential-free
Light switch-off delay 5 s-12 min
Incandescent lamp load 1000 W
Fluorescent lamp load (conventional) not corrected 900 VA
Fluorescent lamp load (conventional) parallel-corrected 200 VA
Fluorescent lamp load (conventional) series-corrected 900 VA
Fluorescent lamp load (conventional) lead-lag circuit 400 VA
Fluorescent lamp load (electronic ballast) 400 VA
Lamps Incandescent/halogen lamps, fluorescent lamps, energy saving lamps, LEDs
Ambient temperature -25 °C … +45 °C
Protection class II
Type of protection IP 54